Item:Silver cigar cutter shaped like a miniature guillotine
Jump to navigation
Jump to search
Incomplete Item
- This item is incomplete, which means that while it is not a stub, it still lacks certain data or information.
- Item Type
- Please see Category:Incomplete items for more items that need updating.
| silver cigar cutter shaped like a miniature guillotine | |
|---|---|
| Look: | A tiny enameled Human executioner is attached to one side and posed as if ready to pull the plunger. |
| Weight: | 5 stones |
| Metal: | Unknown |
| Appraised Cost: | Unknown |
| Properties: |
|
| Dimensions: | 1 length x 1 width x 1 height |
| Sources: | Source is Large bin of miniature figurines |
- Studying your cigar cutter, you think that you can use it to trim a cigar or cigarillo.
- You can accomplish this by holding both and CUT CIGAR WITH cutter.
- You can also poke, turn, push, toss, and clean the cigar cutter.
- POKE: You poke your finger through the guillotine opening in your cigar cutter, but realize that it's a bad idea to cut your finger off, so you pull it back out again.
- TURN: You put your finger through the plunger at the end of your cigar cutter then turn it, letting it sparkle as it swings around in circles.
- PUSH: You lightly push the plunger at the end of your cigar cutter, making the guillotine blade inside the cutter make a sharp *snikt snikt* noise as it slices through the air.
- TOSS: You lightly toss your cigar cutter into the air and then catch it on your finger by the plunger at the end, letting it spin around your finger a few times before grabbing it again in your hand.
- CLEAN: You brush a few errant bits of tobacco off your cigar cutter, then polish it until it shines.