RANGERMAHTRA: Refresh from the latest book dump: recipe entry from the Book of master shaping instructions (verbatim page text; lowest book from the apprentice/journeyman books)

2026-11-12T22:48:05Z

Refresh from the latest book dump: recipe entry from the Book of master shaping instructions (verbatim page text; lowest book from the apprentice/journeyman books)

← Older revision		Revision as of 16:48, 12 November 2026
Line 2:		Line 2:
	\|book=Item:Book of master shaping instructions		\|book=Item:Book of master shaping instructions
	\|chapter=1		\|chapter=1
	\|page=4
	\|tier=Apprentice		\|tier=Apprentice
	\|title=bowcrafting instructions		\|title=bowcrafting instructions

RANGERMAHTRA: Recipe entry from the Book of master shaping instructions (verbatim page text; lowest book from the apprentice/journeyman books)

2026-11-12T21:58:53Z

Recipe entry from the Book of master shaping instructions (verbatim page text; lowest book from the apprentice/journeyman books)

New page

{{Crafting book entry
|book=Item:Book of master shaping instructions
|chapter=1
|page=4
|tier=Apprentice
|title=bowcrafting instructions
}}

==Book page==
<pre>
You page through the chapter and begin to understand how bows are crafted. The first step is to locate lumber in a sufficient quantity for the type of bow being crafted. Although many bow are comprised of a single piece of wood, it is often necessary for have enough lumber on hand to allow the crafter to be selective. The extra wood is also useful in some designs as backing material or inlays for the grips. Crafters should always refer to the ingredients list to ensure all components are on hand before beginning work.
Once the wood is selected and the page is studied, a drawknife is required. By scraping the lumber with the drawknife it will begin to take shape and flatten out where needed. After this step, a carving knife is needed. Repeated carving of the bow stave is necessary, though every piece of wood presents its own challenges. Often the crafter will run into problems that require other tools to sort out.
For example, knots may obstruct the carving process. To remove these you can use a rasp and scrape the unfinished bow. This tiny file is better suited for such delicate work than a knife. Other times the bow may benefit from shaping with a wood shaper more than whittling with the knife.
Composite bows have an additional step here. After assembling in a backer material, they will require the application of glue followed by pushing it into clamps to secure it for drying. Older adhesives would take weeks to cure, but the new formulations set extremely quickly with good results. All bows will need to be pushed into clamps towards the end of the carving process so they may be tested for draw strength and a balanced flexion of the limbs. This step is followed by additional shaping to even out any defects
At last the bow will be ready to be assembled with bow string and finished by applying stain to it. The stain provides sufficient protection from normal use, but an additional finishing enhancement is available to lacquer and seal the material for adventurers seeking a more rugged construction.
</pre>

Item:Book of master shaping instructions/Chapter 1/Bowcrafting instructions - Revision history

RANGERMAHTRA: Refresh from the latest book dump: recipe entry from the Book of master shaping instructions (verbatim page text; lowest book from the apprentice/journeyman books)

RANGERMAHTRA: Recipe entry from the Book of master shaping instructions (verbatim page text; lowest book from the apprentice/journeyman books)